Monday, November 16, 2026

 



Dear friends,

It has been a long time since I last published a post on my blog. Today, I would like to share my latest experimental project involving the CODAN Envoy X1 HF transceiver.

As you may know, the CODAN Envoy is a rather restrictive device when it comes to additional features and external equipment. Many functions require separate licenses or optional features that must be ordered at the time of purchase.

For example, controlling an external RF power amplifier normally requires a dedicated HPA (High Power Amplifier) interface, which I don't have.

Therefore, I decided to design and build a simple circuit board that allows the transceiver to key an external RF power amplifier or control an external receive antenna switch.

The main goal of this project was to achieve this functionality using a simple, inexpensive, and practical solution without relying on additional CODAN hardware.


For my first prototype, I designed a very simple circuit using just a few basic electronic components: a resistor, an optocoupler, a relay, a diode, and a capacitor.

The circuit is easy to assemble and requires only a small number of inexpensive, commonly available components. 

List of components:

  • Optocoupler: TOSHIBA TLP627

  • Resistor: 330 Ω

  • Relay: 12 V DC

  • Diode: Any suitable diode for a 12 V DC relay coil (e.g., 1N4007)

  • Capacitor: 0.1 µF or 0.01 µF ceramic capacitor


I decided to use the TOSHIBA TLP627 optocoupler because it supports a collector-emitter voltage of up to 300 V DC and a maximum collector current of 150 mA, making it suitable for controlling an external relay.

In my case, I selected a 12 V DC relay with a coil current of just 33 mA. Since the TLP627 can handle this current, there is no need for an additional transistor, such as a 2N2222, or any other relay driver circuit.

After examining the CODAN Envoy X1's internal circuitry, I found a PTT-related control point on the band-pass filter board, where a 3.3 V signal appears whenever the transceiver switches to transmit mode (PTT activated).

I decided to use this 3.3 V signal to drive the TLP627 optocoupler through a 320 Ω resistor. This allows me to control an external 12 V relay while maintaining electrical isolation between the transceiver's internal control circuit and the external relay circuit.


Here is The circuit: 














I disconnected the cable from the P300 connector on the Transceiver Control Board (P/N 08-07158-001) and removed the wires from pin 15 (white) and pin 11 (black). These two wires provide power to the cooling fan and are routed to the rear panel of the transceiver alongside the CIB cable connector:




Next, I installed my custom-built circuit board in an available space inside the RF unit (there is plenty of unused space inside the unit) and connected the wires according to the schematic diagram 
shown above:





Next, I connected the black and white wires removed from the P300 connector to the relay's normally open (NO) contacts, which close whenever the transceiver switches to transmit mode (PTT activated).




This is the solution I came up with. I would be happy to hear your thoughts, suggestions, or experiences with similar modifications.

Best wishes to everyone!

73 de 4L2IK